How is the dust bag falling off the bag?

In the process of installation, some dustbags may have problems with bag dropping. These problems usually arise from manufacturers who produce dust bag. In fact, these problems are probably caused by the production process of bag filter, but some manufacturers do not know. The situation. A very important part of the bag filter is the diameter of the flower plate, which is what we call the flower board.

The role of the flower plate is actually very large, mainly to separate the clean air of the turbid air chamber and the clean air chamber, which serves as a working partition. The expansion ring of the dust bag is to firmly clamp the mouth of the flower plate to completely separate the two parts, and there is almost no gap in the middle. This is the relationship between the dust bag and the flower board.

The following two main reasons are the main cause of falling dust bags:

First, the bag filter dust plate hole: the bag hole of the bag filter is stamped, using the die stamping, the large bag filter is made by CNC equipment, the precision is very high, but some manufacturers The manual cutting is used in the production, the precision is far from the equipment, the hole at the edge of the hole is not rounded by the equipment, and there is no gap in one circle. The regularity of the circle also causes the dust ring of the dust bag to not be completely opened or opened excessively, or It is the main reason why the garden is irregular and the oval is open in the expansion ring.

Second, the use of the dust bag expansion ring is wrong, this situation rarely occurs, the general probability is very small. If it does, we will replace the expansion ring for free.

iTP1 (1)

iTP1 (2)

iTP1 (3)

iTP1 (4)

iTP1 (5)

iTP1 (6)

iTP1 (7)

iTP1 (8)

Two Plate Machine

Servo Injection Moulding Machine,Hight Speed Injection Machine,Servo Energy Saving Injection Machine,Two Plate Machine

Demark(changxing)injection system CO. LTD , https://www.petplas.com

This entry was posted in on