Descriptoin:
The Porcelain Ceramic Floor Tile Cutter Machine is capable of cutting ceramic tiles and other similar stone materials. Equipped with infrared ray device, it's capable of preciser cutting. Rubber handle provides better using experience.
Application:
Suitable for cutting stone materials including normal floor tiles, polished tiles, vetrified tiles, etc.
Advantages:
High stength special steel slide rail
Spacial linear bearing block cut parts more accurate
The latest super hard alloy cutter wheel and the latest intelligence briqutting
10mm super rubber sponge compound pads
Specifications:
Max. Cutting Length: 40" (1000mm)
Min. Cutting Width: 1.38" (35mm)
Cutting Thickness: 0.24" - 0.6" (6mm - 15mm)
10mm (0.39") Rubber Sponge Compond Pads
Steel Slide Rail
Alloy Cutter Wheel
Useage
Â
Since the height of the filling is close to the tower top, the water eliminator does not occupy much space, and the overall height of the cross-flow tower is small, which makes it relatively compact compared with counter flow type, and therefore lower air inlet speed and power consumption as well.
The cross-flow tower adopts a water distribution system that will let the water drop fall naturally by gravity. Thereby, water distribution holes are not easy to be blocked, as water distribution is even and maximizes the performance of the tower fillings. The inspection manhole also enables routinely maintenance without machine shutdown.
A lower part of the cross-flow tower filling is submerged in the water, so that the water flows through the surface of the filling and directly falls into the below tank, making low noise.
The cross-flow tower fan is located in the middle of the Cooling Tower, while the filling, on both sides of the tower. So the amount of splashing water is very small.
Cross Flow Cooling Tower,Cooling Tower Cools Water,Induced Draught Cooling Tower,Induced Draft Cross Flow Cooling Tower
Guangdong Jiema Energy Saving Technology Co.,Ltd , https://www.heatexchangerjiema.com