Mercury ore single flotation process at the McDermott plant in the United States

The picture below shows the single flotation process for mercury ore at the Mc Dermitt plant. The main mercury-containing minerals are cinnabar and chlorsulfurite, with a ratio of 7:3, an average Hg of 0.5%, and the current mining grade is as high as 1%; the gangue is about 20% of the opal, and the remaining 80% is soft with a large amount of clay . Sexual alteration rock. The collector was treated with isopropyl xanthate and foaming agent No. 250. The cyclone overflow fineness is 65~75%-200 mesh. Floating mineral slurry concentration of 20%.

Figure US McDermott plant selection production flow chart

Medical Oxygen Generator are normally installed in hospitals and clinics, especially for remote areas where cylinder oxygen is difficult to buy.

Medical Oxygen Generator has similar structure with Industrial Oxygen Generator, just at the end pipelines, there are bacteria remover and odd smell remover. Oxygen generator uses Air Compressor to get raw material, the compressed air. The compressed air is treated by air treatment part, which has oil remover, filters and dryer. After treatment, clean air goes to oxygen separator. In this part, the oxygen in the air is separated and collected from top of machine, then goes into a buffer tank to make flow rate stable. At the end of buffer tank, there is flow rate meter and analyzer,etc to adjust flow rate and test oxygen purity.

Details process is as below:

Psa Oxygen Generator Process Flow

Medical Oxygen Generator Specification:

Flow rate: 1-200 Nm3/hr

Purity: 90-95%

Outlet pressure: 5-10 bars

Medical Oxygen Generator

Medical Oxygen Generator,Medical Oxygen Generators,Medical PSA Oxygen Generator

Shandong Gamma Gas Engineering Co. Ltd. , https://www.gammagas.com